Enable diag on Netgear MR1100

Enabling diag you can access to modem with Qualcomm tools and collect modem logs. First at all you have to access via Telnet to MR1100 device. When you have connected, run ATI command to confirm you have connected. This should print out details about device and IMEI. ati Manufacturer: Netgear, Incorporated Model: MR1100 Revision: NTG9X50C_12.06.12.00 r3840 ntgrbc-fwbuild4 2020/04/26 23:12:17 IMEI: 3591260XXXXXXX IMEI SV: 14 FSN: 5D6181ND00414 +GCAP: +CGSM Then run AT!OPENCND? command to get generated challenge. ...

June 16, 2021 · 1 min · minh
photo_2019-08-17_12-07-12

Netgear Nighthawk MR1100 and MR2100 supported 4G CA Combinations

Most of the mobile device manufactures don’t tell you of supported 4G LTE CA ( Carrier Aggrecation) combinations on their hardware specifications but these are very important to know because they are the key factor to get best performance on your device and network. We are not quite sure why manufacturers are so reluctant to publish this information but one of the reason could be that it is quite complicated. Many devices have carrier policy which will tell the modem to limit combinations because if device supports over 128 combinations the modem will slow down. Therefore it is better to limit CA combinations per mobile phone operator. ...

August 17, 2019 · 2 min · minh
Netgear-MR1100-taajuuslukko

Enable manual band selection on Netgear MR1100

By default on Netgear MR1100 mobile router doesn’t allow manual band selection / locking on device settings but there is way to add band selection to Netgear via telnet-console. On this instruction, i use EU-version of Netgear MR100 and firmware version NTG9X50C_12.06.03.00. Check supported 4G CA combinations on another article. Access via telnet to Netgear MR1100 To add bands to your Netgear MR1100 device, you must first connect Netgear router to your computer via USB-cable. ...

March 30, 2019 · 3 min · minh